...
Refresh fabric element dispatch after Region/Module modification in order to visualized new floorplanning
Until Place 1/5 step, regions can be manually edited though the floorplan view using Edit regions command.
| Anchor | ||||
|---|---|---|---|---|
|
...
To do so, select a defined regions among the listed ones and it will be highlighted in blank into the floorplan, allowing to expand or decrease left, right corners dimensions of the region at top and bottom.
| Anchor | ||||
|---|---|---|---|---|
|
...
Once the region has been edited, don’t forget to validate the changes by clicking on Tools → Apply constraints.
Docks
NXmap provides a dedicated Regions using Regions dock widget, which allows various actions through several right click menus:
outside existing regions, the logic is scattered into the fabric (identified as top level element with ‘~') and a right click on this gives access to General and Region '~’ menus
General allows to Edit Fabric dimensions inside which logic should be mapped, Create a Region or Create an Obstruction from scratch
Region ‘~’ allows to edit the dimensions of the top level '~’ region of the design
| Anchor | ||||
|---|---|---|---|---|
|
...
You can parse a list of Regions/Obstructions using
| Anchor | ||||
|---|---|---|---|---|
|
...
| Anchor | ||||
|---|---|---|---|---|
|