...
| Note |
|---|
The TimingDriven efficiency is in continuous development and improvement. |
...
Floor planning
In order to give indications to the tool, the user can set up a floor-planning and pass it through the tool working directly on the whole design with ConstrainModule or ConstraintPath methods or working with unitary runs before integrating in the top design . Please refer to #Floor_planning.as specified in #Floor_planning_Preplace_ip.
First of all, ConstrainModule methods as explained in #Floor_planning_Constrain_module must be applied in order to concentrate parts of the design and place them close to other ones if interconnections between them.
In addition, ConstraintPath methods as explained in #Floor_planning_Constrain_path_between_registers must be applied if some path go trough multiple modules or for last critical paths.
| Note |
|---|
With this solution, the user must pay attention to interconnections between modules and between module and output interfaces. |