...
Before install Impulse, check that Python 3.6 is installed with below command:
Code Block $> which python3
If Pyhton3 is installed you will see the following line:
Code Block $> /usr/bin/python3
If Python3 is not installed, run the following command:
Code Block $> sudo yum install python3
To install Impulse, update ~/.bashrc file with below instruction:
Code Block export PATH=/opt/NanoXplore/impulse-/bin:$PATH
Check that ~/.bashrc updating has been taken into account with below command:
Code Block $> source ~/.bashrc”
Check that Impulse is installed with below commands:
Code Block $> which impulse
The result of this command must be the following
Code Block $> /opt/NanoXplore/impulse-version/bin/impulse
Check that Impulse works correctly with Impulse is working as expected by running the following command:
Code Block $> impulse -version
The result of this command must be the following
How to Install NxBase2
Navigate to the NanoXplore tools directory:
Code Block $> cd /opt/NanoXplore
Create a new folder named NxBase2-2.5.3:
Code Block $> sudo mkdir NxBase2-2.5.3
Extract the NxBase2 TAR archive to the /opt/NanoXplore folder:
Code Block $> sudo tar xvf NxBase2-2.5.3.tar.bz2 -C ./NxBase2-2.5.3
...
Plug your ANGIE device to your system using the USB cable provided
Check the board is detected using the below command:
Code Block $> lsusb
The result should look like the screenshot below:
...
Configure ANGIE Access Rights
...