Page Comparison

...

1. Before install Impulse, check that Python 3.6 is installed with below command:

   Code Block
   $> which python3

   If Pyhton3 is installed you will see the following line:

   Code Block
   $> /usr/bin/python3

2. If Python3 is not installed, run the following command:

   Code Block
   $> sudo yum install python3

3. To install Impulse, update ~/.bashrc file with below instruction:

   Code Block
   export PATH=/opt/NanoXplore/impulse-/bin:$PATH

   Check that ~/.bashrc updating has been taken into account with below command:

   Code Block
   $> source ~/.bashrc”

4. Check that Impulse is installed with below commands:

   Code Block
   $> which impulse

   The result of this command must be the following

   Code Block
   $> /opt/NanoXplore/impulse-version/bin/impulse

5. Check that Impulse works correctly with the following command:

   Code Block
   $> impulse -version

   The result of this command must be the following

   Image RemovedImage Added

How to Install NxBase2

...

1. Create a file named “99-nanoxbase.rules”

2. Add the following lines to “99-nanoxbase.rules”:

   Code Block

   ACTION=="add", SUBSYSTEM=="usb", ATTRS{idVendor}=="8613", ATTRS{idProduct}=="584e", MODE="660", GROUP="plugdev" ACTION=="add", SUBSYSTEM=="usb", ATTRS{idVendor}=="584e", ATTRS{idProduct}=="424e", MODE="660", GROUP="plugdev" ACTION=="add", SUBSYSTEM=="usb", ATTRS{idVendor}=="584e", ATTRS{idProduct}=="4242", MODE="660", GROUP="plugdev" ACTION=="add", SUBSYSTEM=="usb", ATTRS{idVendor}=="584e", ATTRS{idProduct}=="4342", MODE="660", GROUP="plugdev" ACTION=="add", SUBSYSTEM=="usb", ATTRS{idVendor}=="584e", ATTRS{idProduct}=="4a55", MODE="660", GROUP="plugdev" ACTION=="add", SUBSYSTEM=="usb", ATTRS{idVendor}=="58c0", ATTRS{idProduct}=="804e", MODE="660", GROUP="plugdev"

3. Copy this file to /etc/udev/rules.d directory using the command below:

   Code Block
   $> sudo cp 99-nanoxbase.rules /etc/udev/rules.d

4. Either:

   • Reload the udev rules with the following command:

     Code Block
     $> udevadm control –reload-rules

   Restart

   • Or simply restart your machine after the above command

5. Check that the board is detected using the below command:

   Code Block
   $> lsusb

   

...