The Ngultra devkit peripheral has two types of commands: Set jumper values and Get jumper values.

Set jumper values:

Activate/de-activate a por_reset on devkit:

#quick reset (on & off)
ngultra_devkit.py --set --por_reset

#reset on
ngultra_devkit.py --set --por_reset --value 0

#reset off
ngultra_devkit.py --set --por_reset --value 1

Set mode to Normal0, Normal1:

ngultra_devkit.py --set --mode --value Normal0

Set boot source to SPI or SPACEWIRE:

ngultra_devkit.py --set --boot_src --value SPI

Set flash mode to SEQUENTIAL or TMR:

ngultra_devkit.py --set --flash_mode --value SEQUENTIAL

Set flash number 0, 1, 2 or 3:

ngultra_devkit.py --set --flash_number --value 2

Get jumper values:

Warning: Get operation works only if a set has been done before.

Get reset state if: on or off:

ngultra_devkit.py --get --por_reset

Get mode if: Normal0, Normal1:

ngultra_devkit.py --get --mode

Get boot source if: SPI or SPACEWIRE:

ngultra_devkit.py --get --boot_src

Get flash mode if: SEQUENTIAL or TMR:

ngultra_devkit.py --get --flash_mode

Get flash number if: 0, 1, 2 or 3:

ngultra_devkit.py --get --flash_number

Browser not supported